Stripe Reader S700/S710 is an Android-based smart reader for countertop and handheld use.
1. Charge the Reader
- Connect the reader to power by plugging the provided USB-C cable into the port on the left side of your reader. Connect the opposite end of the USB-C cable to the provided power adapter and plug it into a power outlet. After the reader is fully charged, hold down the power button on the right side until the screen turns on. After the device powers on, press the power button to sleep or wake the device. To fully power off the device, hold down the power button until the power off option appears on the screen. Even when not in use, it is suggested to leave the Stripe Reader S700/S710 plugged in and powered on to receive automatic software updates.
2. Open Settings
- To open the settings menu, swipe right from the left edge of the reader screen to reveal a Settings button. Tap the Settings button and enter the admin PIN 07139. From here, you can update your WiFi settings or generate a pairing code for device registration.
3. Connect to the Internet
- For Wireless: To connect to WiFi or switch networks, go to settings, then select WiFi settings to choose the network and connect.
- For Wired: Connect the Ethernet cable from your hub to your router. Connect the hub to power through the built-in USB-C cable. We recommend using the power adapter included with your tripe Reader S700/S710 to make sure the appropriate power is provided to the hub. Connect the USB-C cable provided with Stripe Reader S700/S710 to the hub and reader when both cables are in place. The right-angle USB-C connector connects to the reader. To confirm the reader’s Ethernet connectivity, verify that the reader is charging and check if the Ethernet icon is visible in the status bar.
Charging icon
Ethernet icon
4. Add Stripe Reader
- Open settings on your reader, enter admin pin 07139 and generate pairing code. Next go to TeeOn and open settings -> payments -> card readers -> new card reader. Label the reader with whatever name makes sense (Proshop 1, Proshop 2, Kitchen, etc) and under "registration code" type in the pairing code given to you by the reader. Add register group for whichever register is linked to the reader (Proshop, Kitchen, etc) and press "create."